Cost-effective wideband dielectric planar lens antenna for millimeter wave applications

José Manuel Poyanco, Francisco Pizarro, Eva Rajo-Iglesias

Resultado de la investigación: Contribución a una revistaArtículorevisión exhaustiva

3 Citas (Scopus)

Resumen

This article presents a fully 3D-printed dielectric planar lens operating in the entire Ka-band manufactured using additive manufacturing and a relatively low-cost 3D-printer. The lens consists of ten concentric rings implemented using low-loss ABS filaments with high permittivity values. By varying the infill percentages of them the required refractive indexes of each section are achieved. An additional 3D-printed matching layer, using the same manufacturing and design method was included in the lens, to reduce reflections. Simulation and measurement results show a very good agreement, which confirms the possibility of manufacturing a cost-effective broadband and planar lens solution operating in millimeter wave bands, where Low Earth Orbit Satellites (LEO) networks, future mobile communication systems (5G, 6G) and radar systems operate.

Idioma originalInglés
Número de artículo4204
PublicaciónScientific Reports
Volumen12
N.º1
DOI
EstadoPublicada - dic. 2022
Publicado de forma externa

Huella

Profundice en los temas de investigación de 'Cost-effective wideband dielectric planar lens antenna for millimeter wave applications'. En conjunto forman una huella única.

Citar esto